Mike's Oud Forums
Not logged in [Login - Register]
Search the forums Search   Frequently Asked Questions FAQ   View member list Member List   Today's Posts Today's Posts   Forum Stats Stats   Board Rules Board Rules THREADWALKER OUD FAQ THREAD Back to: Mike's Oud Website
Mike's Oud Forums » Oud Maintenance Forum » Advice, Tips, & Questions » Sanding a fingerboard. Question? Go To Bottom

Printable Version  
Author: Subject: Sanding a fingerboard. Question?
charlie oud
Oud Junkie
*****



Posts: 694
Registered: 11-19-2007
Location: Newcastle upon tyne. UK
Member Is Offline

Mood: chords prefer frets

[*] posted on 9-20-2017 at 12:32 AM
Sanding a fingerboard. Question?

Dear members, I have read on this forum and else where that when sanding an oud fingerboard the sanding block needs to be as long or longer than the fingerboard so an even sanding can happen. Surely if this is the case then the sanding paper used with the block needs to be as long or longer than the fingerboard also. Can you buy paper this size? or am I misunderstanding something about all this. Cheers



Best Wishes, Charlie
View user's profile View All Posts By User
SamirCanada
Moderator
******



Posts: 3405
Registered: 6-4-2004
Member Is Offline


[*] posted on 9-20-2017 at 05:47 AM


you are fine with a block the length of a regular sand paper sheet.

I would say, use a piece of MDF as its pretty much dead flat.



@samiroud Instagram
samiroudmaker@gmail.com
View user's profile View All Posts By User
charlie oud
Oud Junkie
*****



Posts: 694
Registered: 11-19-2007
Location: Newcastle upon tyne. UK
Member Is Offline

Mood: chords prefer frets

[*] posted on 9-20-2017 at 06:27 AM


Thank you Samir. Appreciate your help.



Best Wishes, Charlie
View user's profile View All Posts By User

 Mike's Oud Forums » Oud Maintenance Forum » Advice, Tips, & Questions » Sanding a fingerboard. Question?   Go To Top

Powered by XMB
XMB Forum Software © 2001-2011 The XMB Group