nadir
Oud Junkie
   
Posts: 329
Registered: 12-29-2003
Location: USA
Member Is Offline
Mood: No Mood
|
|
inlay or not to inlay?
i was just wondering if inlay affects the sound quality of the oud if it is put on the fingerboard and/or the face of the instrument? also, would the
material used (ivory, mother of pearl,...) for inlay affect the sound as well?
|
|
Mike
Super Administrator
       
Posts: 1568
Registered: 12-3-2002
Location: California, USA
Member Is Offline
Mood: Happy
|
|
That's a good question Nadir. There was a nice discussion about this on the Oud Home Page Message Board awhile ago. Personally, I like a little inlay on the edge of the fingerboard, and I
like wood in wood inlay. Check out Jameel Abraham's oud gallery to see a cool inlay design on the edges of the fingerboard and perimeter of the
face.
|
|
Rufi
Oud Addict
 
Posts: 46
Registered: 12-19-2003
Member Is Offline
Mood: Knowlege seeker
|
|
Inlay
In my opinion Mother of pearl and abalone inlay can be good or bad. It all depends on how it is done. The Problem that people have with it is that
it is a heay material, calcium carbonate. It weighs like a stone. If the Inlay Is too thick it will be heavy and in the top of an oud weight is
critical. Ivory is also very heavy and dense as bone is too. When I inlay an oud I am very careful to make sure that it is thin enough as to not
weigh down and choke the vibrations. The fingerboard is a different story.
The problem with inlay in the fingerboard of a frettless Instrument is that many inlay materials are harder than the wood that they are inlayed into.
so over time the wood wears quicker than the inlay and you develop problems with buzzing. you can level the finger board to over come this problem
but if you sand to much you sand through the inlay and thats no good either.
I like to make my fingerboards out of hard materials like ebony to help avoid this problem. all Fingerboards need to be replaced some time so keep
this in mind too. peace Be Rufi
|
|
nadir
Oud Junkie
   
Posts: 329
Registered: 12-29-2003
Location: USA
Member Is Offline
Mood: No Mood
|
|
thank you SO MUCH for this advice, i've actually found an oud that has an inlay of wood (but im not sure what it is... the color is gray though,
it's beautiful!) anyways, thanks again for the advice!
|
|
Adel
Oud Maniac
  
Posts: 90
Registered: 12-7-2003
Member Is Offline
Mood: No Mood
|
|
Inlay
I agree with you Rufi,
Too much inlay will kill the sound of the oud, and it makes it both impossible and very expensive to repair.
The best ouds that I came across in my life as an oud player, has been very simple ouds in the design, I take an example of Al Sunbaty and Al Qasabjy
ouds.
The best Nahats I have seen and played have no decoration.
Salamat,
Adel
|
|